Routine Maintennace

1 Reply 1,404 Views
Raters
Participants
Thread Starter #1
I am curious to know how you all do the routine aquarium maintenance. Have you purchased any new equipment recently?
#2
I do a quarterly maintenance schedule now ever since I got this turtle tank setup and going on all of my tanks. I will effectively take apart the canister filter, take all of the sludge out from it, clean off the impeller and inspect it, check the rubber o-rings and gaskets are all looking in good health, and then will clean the sand out of the tank by mixing it all up while doing a water change. 

Normally try to have it to where when I put in all of the clean & fresh water that it doesn’t kick up that much dirt/debris (if I see a lot getting kicked up, I will do another tank draining and try to find the dead spots where everything settles and use my gravel vac to suck that all up).

I tend to avoid buying new equipment unless I start to see a severe decrease in flow that isn’t caused by a impeller getting stuck but rather a motor slowly giving out (you can always tell as the location of where the motor is at will be abnormally warm on the outside of the canister filter - or for a HOB, it will be warm if the motor sits outside of the filter case itself). I want to say the last time I had to buy something new (if we exclude our filter media such as sponges, those plastic gravel balls, etc) was a few years ago if I can recall correctly (definitely before COVID).

You must be logged in to reply.

0 quotes selected